• Tentacle T3 for Raspberry Pi


The Tentacle T3 eliminates the need for wiring, multiplexing and electrical isolation. Because it comes in a Raspberry Pi HAT form factor, it simply plugs into your Raspi. No wiring, no bread boards.

It’s stackable and hosts up to 5 EZO devices from Atlas Scientific to measure PH, Dissolved Oxygen, Electric Conductivity (E.C.), Oxidation-Reduction Potential (ORP) temperature (RTD), peristaltic pump (EZO-PMP).

The Tentacle T3 is compatible with Raspberry Pi 2, 3, 4 and Zero.

EZO Circuits are not included.


The Tentacle T3 gives you 2 fully isolated channels for EZO circuits made by Atlas Scientific. Channel 3 is also in the EZO form factor and is perfect to add  RTD Temperature compensation to your isolated channels. An additional 2 channels allow you to connect 5-pin devices by Atlas Scientific that come with a Molex connector. These channels can also be used as generic additional I2C connectors.


Channel 1 and 2 are fully isolated. Built in electrical isolation means that sensors won’t interfere with each other and most outside electrical noise that can interfere with readings is reduced.


By specification, Raspberry HATs are not stackable (That’s why the Tentacle isn’t allowed to be called a HAT). With the Tentacle T3 however you can stack multiple HATs to your Pi. You can stack multiple T3’s, or stack another, normally not stackable HAT on top of the Tentacle. You can easily stack 2 to get 4 isolated channels and 10 channels in total! If you have a beefy power supply and feel like messing with the pullup resistors on board, you can stack even more.

The Tentacle comes with an M2.5 standoff mounting kit.

You can also stack other HATs (that are not stackable by design). For them, the Tentacle is mostly transparent. The Tentacle doesn’t “occupy” any pins of the Raspberry. It’s connected to 5V, 3.3V, GND, SCL, SDA. The Tentacle adds pullup resistors to the I2C line so you don’t have to care about them.

Write a review

Please login or register to review

Tentacle T3 for Raspberry Pi

  • 120.94€

  • Ex Tax: 99.95€

Related Products



Description:Connect any off-the-shelve pH probes to your microprocessor that supports UART or I2C...

54.39€ Ex Tax: 44.95€

EZO™ RTD Circuit

EZO™ RTD Circuit

Description:Connect any PT-100 or PT-1000 temperature probe and get the values by UART or I2C. Ext..

38.72€ Ex Tax: 32.00€

EZO™ Conductivity Circuit  ( # EZO-EC )

EZO™ Conductivity Circuit ( # EZO-EC )

Description:Connect any off-the-shelve conductivity probe to your microprocessor that supports U..

82.28€ Ex Tax: 68.00€