The EZO™ Advanced pump kit comes with everything found in our original EZO pump kit and more!
Having the pump already mounted into an enclosure saves a lot of time.
The power connector and data cable with breakout board make integration onto your device FAST!
*This device comes defaulted to I2C mode*
*You can switch it back to UART mode if desired*
| Enclosure: | |
| Size | Metric: L = 145mm x W = 90.5mm x H = 80mm |
| Inch: L = 5.7″ x W = 3.5″ x H = 3.1″ | |
| Enclosure protection | IP-64 |
| Enclosure material | Body: Polycarbonate plastic |
| Screws: Stainless steel | |
| Pump: | *This pump is set to I2C mode by defualt* |
| *It can be change to UART mode.* | |
| *See data sheet for instructions* | |
| Flow rate | 0.5ml to 105ml/mins |
| Accuracy | +/- 1% |
| Modes of operation | Continuous dispensing Volume dispensing Dose over time mode Constant flow rate Dispense at startup |
| Connector | 5 lead data cable |
| Calibration | Single point |
| Supplied tubing | 15.24 cm |
| Tubing size | Any 5mm O.D. tubing |
| Data protocol | UART & I2C |
| Default I2C address | 103 (0x67) |
| Operating voltage | 3.3V – 5V (logic) |
| 12V – 24V (motor) | |
| Pump head | 2 meters |
| Data format | ASCII |
| Food safe | Yes |
We change the power supply for a EU type
EZO-PMP™ Advanced Kit ( SGL-PMP-BX™ )
- Brand: Atlas-Scientific
- Product Code: EZO-ADV-PMP
- Availability: In Stock
-
172.95€
- Ex Tax: 142.93€