Description:
The 'MotoMama' is a motor drivers shield for Arduino, based on L298N H-bridge driver chip. You can use this shield to drive two DC motors or an four-wire two-phase stepper motors with Arduino boards. The L298N chip is capable of currents till 2 A (up to 3.0 A for short periods and 2.5 A with 80% On (20 ms) / 20% Off ), max. Voltage for the motor(s) is 50 V.

This board can be used as an Arduino shield (comes with separate male headers and even stackable headers for connection on an Arduino board) or as a standalone operation with any other micro-controller. Board has a 5V power supply connector to run the L298N chip logics, this can also power the Arduino board. You can directly put a XBee (or other XBee pins compatible module, like BTBee) and a nRF24l01 module on the board for wireless communication. 4 Arduino pins are available to connect sensors, AD0 - AD4

Specifications:

• L298N H-bridge driver chip
• Drives 2 x DC or 1 x bipolar stepper (max 2.5 A)
• Can be used as Arduino Shield
• Chip cooled via on board Heat Sink
• Includes 2 x 40p male headers and stackable header Kit

Resources:
Contact us for datasheet and Libraries