Description:
In complex mechanical systems, it is often very difficult to accurately measure the movement of a single part, particularly if it has several degrees of freedom. The draw wire potentiometer is a versatile solution to this very problem; it can be attached to a part using an M5 screw or fastened to the end with a zip tie, and the potentiometer itself has a pair of M5 screw threads on the back for easy installation.

When the wire is pulled out, the sensor produces a voltage to describe the length of wire exposed. The reel is spring loaded, so it will retract when there is no tension in the wire. Multiple draw wire sensors could be used to track the position in more than one dimension.

Specifications POT4200_0:

Sensor Properties

Electrical Properties

Physical Properties

Resources:

• Mechanical Drawings

How to Wire:

You can connect this potentiometer to any board or micro controller that has an analogue input by soldering a sensor cable to the wires as described below: