Description
Our friends at Atlas Scientific, were in need of very accurate humidity monitoring. If the humidity is too high, they can’t manufacture sensors; if it’s too low static electricity becomes an issue. Finding a high-quality humidity sensor was harder than thought. So, the Atlas team built their own sensor. These sensors can be found all over the place to make sure the humidity is always kept within range. Atlas loves them, and we believe you will too. Now on order!

This sensor can be screwed into position, has a 1 meter cable and a 5 pin standard connector, which is breadboard friendly using the male header.

Steel version of the sensor!

• Reads: Relative humidity, Dew point, Air temperature
• Range: 0 – 100%
• Calibration: Factory calibrated
• Response time: 1 reading per second (UART mode), 1 reading per 300 milliseconds (I2C mode)
• Accuracy: +/- 2%
• Connector: 5 lead data cable
• Cable length: 1 meter
• Data protocol: UART & I2C Default I2C address 111 (0x6F)
• Data format: ASCII
• Operating voltage: 3.3V − 5V
• IP rating: IP67 (waterproof up to 1 meter)
• Life expectancy: 10 years

Resources:

Link to the Atlas product page